Inside Gift Card Holder using the Gift Wrapped Bundle!

Today’s project uses a retired bundle but because the inside of the card is so neat, I still wanted to post it for you because you can use your own stamp set to decorate the front of your card. I wanted to show you all of the steps so you could try this out!

This is what the inside of my card looks like:

Follow along!

Step 1: Cut a cardstock piece to measure 11″ x 5-1/2″. Score in the center at 5-1/2″.

Score again at 4-1/4″. Turn the cardstock to the opposite end and score again at 4-1/4:

Step 2: Fold on the score lines to form a mountain fold in the center:

Step 3: Place a gift card over the mountain fold and add tick marks with

a pencil about 1/4″ on each side of the gift card. You want the hole to be larger

than the gift card. Use the Classic Label Punch lined up to the first pencil

mark and half-way on the scored line like you see in the photo below and punch:

Step 4: Slide the punch over to the next pencil mark and line up with

the first slot that was punched to make a longer slot:

Step 5: Open the fold in the center and this is what the slot should look like:

Step 6: Add Tear & Tape to the bottom of one side:

Step 7: Peel the backing of the Tear & Tape and press the two sides together.

Insert the gift card in the slot and finish the inside and front of the card.

Will you be placing an order today? If so, please use the monthly hostess code when prompted at checkout to earn free products from me. If your order is $150 of more, no need to add the code so you can earn your own hostess rewards! Thank you so much for supporting a small business owner!